There was an early idea that I tried with Tomba7, but was not reliable. I suppose this newer modification might be much better.
The difference is in using PU as on image. I already have an older type TombaF800 (it was using OR 7 x 2.5 mm, for 8 mm shaft) so I can use it just replacing the O-ring with 7 x 3 mm so it will seal 7 mm shaft. I already have tested the sealing. It seems to be OK even if bending the shaft during loading. Slider that I wont to use is actually micro slider for "free shaft". So this spear will be like a spear for free shaft with micro slider, but without a piece of line tied to the front end of the shaft. Final design of the slider will be slightly different, probably made in titanium.
Il ya eu une première idée que je ai essayé avec Tomba7, mais ne était pas fiable. Je suppose que cette modification récente pourrait être beaucoup mieux.
La différence est dans l'utilisation de PU comme sur l'image. Je ai déjà un type plus ancien TombaF800 (il a été d'utiliser ou de 7 x 2,5 mm, pour arbre de 8 mm) pour que je puisse l'utiliser simplement remplacer le joint torique avec 7 x 3 mm de sorte qu'il va sceller 7 arbre de mm. Je ai déjà testé l'étanchéité. Il semble être OK, même si la flexion de l'arbre pendant le chargement. Curseur que je ne vais pas à utiliser est effectivement micro curseur pour "arbre libre". Donc cette lance sera comme une lance pour arbre gratuit avec micro curseur, mais sans un morceau de ligne attaché à l'extrémité avant de l'arbre. La conception finale du curseur sera légèrement différente, probablement en titane.